Translogic Translogic QSXi Intellishift Quickshifter – universal two-cylinder

Translogic QSXi Intellishift quickshifter for two-cylinder engines with two +12 volt coils and fuel injection. Not suitable for single-cylinder engines with one coil and injector, nor for CDI ignition.

Can be used with the standard road pattern (1 down, 5 up) and with the reversed race pattern (1 up, 5 down).

• This system is not plug and play. A crimp tool, solderless connectors and heat shrink are supplied; the interrupt wires have to be joined to the +12V supply of the ignition coils.

On an upshift the QSXi interrupts ignition cylinder by cylinder rather than pulling the signal to ground. That is kinder to the original ECU and gives a cleaner shift. The electronics adapt the interrupt to engine speed and load, so a shift at low revs is as clean as one at full throttle.

Setting up happens on the ECU itself: sensor trigger force and interrupt time per channel. No laptop, phone or dyno time involved.

Supplied with: QSXi Intellishift ECU, DCS shift sensor and the matching tie-rod or tie-rod kit.

Check that your bike matches the description above before ordering.